Trident Make Heatless Air Dryer WORKING PRINCIPLE Drying Cycle : Moist air from the compressor is sent through the coalescing filter. Here water & oil coalesces and purges through the auto drain valve. The relatively clean air with water vapour passing through the aluminum drying tower filled with desiccant gets completely dried (up to -400C PDP) and then passes through a built in after filter (25 micron). The desiccant fines from the towers are completely removed and clean dry air is let out through the outlet port for use. Regeneration Cycle: During the regeneration cycle, the sudden depressurisation brings out water molecule strapped in the Desiccant pores to the surface of the beads. A small portion of dry compressed air from the drying tower then passes over the desiccant through the regeneration orifice built in the Top Block. This results in complete regeneration of the Desiccant. Dryers Features: ApplicationPainting And Powder Coating, Machine Tool, PackagingApplication, Auto Garage, Textile & Garment, Instrumentation, Pharmaceutical, Dental Laboratory, Rail Vehicles, Telecomm industry (pressurises its underground cables to repel moisture and avoid shorts), Pneumatic control systems, Feed air for Zeolite type Oxygen and Nitrogen generators, Truck and Train Air brake systems. SpecificationsMaximum Operating Pressure : 16 kg/cm2(g)Air Inlet Temperature : 380C MaxOperating Pressure : 7 kg/cm2(g)Pre-Filter Rating : 0.01 MicronCycle Time : 4 MinutesOperating Voltage : 100-240 VAC 50/60 Hz 1 PhOutlet Conditions : Dry air at -400C PDP*Purge Loss : 15±1% Available Range : 10 CFm to 375 CFM Generally This heatless air dryer are used with oil free compressor. Please check the below post for oil free compressors. See Also : Trident Make Refrigerated Air Dryer Your Inquiry is Important To Us. Submit Now.
Refrigerated Air Dryer
Trident Make Refrigerated Air Dryer Working PrincipleThe principle on which the refrigerant air dryer manufacturing takes place and subsequently works is that cooling of compressed air cause condensation of water that is carried by the compressed air in vapour form. The cooling takes place in two stages in the refrigerated type of air dryer. The compressed air enters the refrigerated type of air dryer at about 40 degree Celsius. It enters the pre-cooler firstly wherein the outgoing cool-dry air cools the incoming hot-wet air. The outgoing cool-dry air on the other hand is heated upto an operating temperature of about 28-32 degree Celsius. This partially cooled hot-wet air then enters the evaporator wherein it is chilled down to a temperature of about 2-8 degree Celsius. The chilling down of the hot-wet air condenses the moisture bored by the air in vapor form. Next, the chilled air bearing condensed moisture is subjected into the moisture separator, which is a mechanical equipment that helps separate the condensed moisture from the air by mechanical activity. The moisture separator drains out the moisture via an automatic drain valvThis cool-dry air is then passed through the pre-cooler as mentioned above. In a nutshell, this process produces dry air which can be obtained through the outlet. This dry air is of a pressure dew point temperature of about 4 degree Celsius or as required but above 2 degree Celsius. The amount of power consumed by drying air in the refrigerated air dryers is approximately 5.0 kwh for 1000 cubic feet per minute of air.Dryer Features : Available Range : 20 CFM to 1000 CFM Generally This refrigerated air dryer are used with lubricated air compressor. Please check the below post for lubricated compressor. See Also : Trident make Heatless Air Dryer Your Inquiry is Important To Us. Submit Now.